Browsed by
Category: Ruckus

Ruckus Unleashed Gateway Mode setup: The thing Ruckus didn’t tell you

Ruckus Unleashed Gateway Mode setup: The thing Ruckus didn’t tell you

Having problems setting up a gateway mode on Ruckus Unleashed access points that have a single RJ45 connector? You’re not the only one. During a test here in the office, I just found out that enabling Gateway Mode on the Unleashed Master during the setup makes it impossible to pair other new access points, even with Mesh enabled. The problem is that other new access points don’t have the meshing data just yet and since the master AP only possesses…

Read More Read More

Wireless network loop, Point-to-point down

Wireless network loop, Point-to-point down

Hey all, Today one of my wireless networks pulled me a new one. I had basically created a loop in the network, but it took a while to figure this one out. I had noticed in the virtual SmartZone that the network of one of our APs had started to mesh differently from our design. So much so, that even management of some remote AP’s became a bit sluggish. The network is set up with several Ruckus P300 point-to-point AP’s to…

Read More Read More

Ruckus Unleashed APs disassociate from their master AP

Ruckus Unleashed APs disassociate from their master AP

In my first, technical post, I’d like to go a bit more in-depth on a technical issue I’ve encountered in my work. Working with Ruckus products, I’ve had my fair share of experience and troubles with the new Unleashed series. Unleashed is a product series that integrates a selection of zonedirector features into the APs, to allow for a cheaper network deployment. Unleashed is limited to 512 simultaneous clients and a maximum of 25 APs in the network. Furthermore a…

Read More Read More

%d bloggers like this: